
Robot Survives 1000C Heat

A tracked firefighting robot built in Beijing reportedly spent 30 minutes inside a furnace heated to 1,000°C and came out still working. Beijing Lesentech rates its RXR-M80D-AX2 for continuous operation above 1,000°C for more than half an hour, and Interesting Engineering reported the demonstration. Lesentech calls it the first robot able to work in that heat.

The machine exists for the compartments a crew cannot enter. The company names industrial plants, warehouses and chemical sites, where heat and gas rule out sending a crew in with a hose. So the robot carries the hose instead.
Heat is the hard part, because every system on a mobile machine has to survive at once. Lesentech says several patented thermal protection measures shield the motors, control electronics, cameras and batteries inside an IP65 enclosure that keeps out dust and water jets. And the finished vehicle weighs 800 kg, with a body of 1,750 by 1,100 by 1,200 mm.
The working end is a water and foam cannon that moves 80 litres a second to a maximum range of 85 metres at 1.0 MPa. It throws either a concentrated jet or a mist spray, swings 30 degrees each side of centre, and tilts from 15 degrees below horizontal to 75 degrees above.
On the move, the robot is rated at 1.5 metres per second, able to climb 30 degree slopes, cross trenches 400 mm wide and clear obstacles 170 mm high, with four hours of endurance. An operator drives it by remote control over a line of sight radio link of up to 1 km, watching a 10 inch screen fed by body cameras and a thermal imager on the cannon.
The sensor head watches for carbon monoxide, methane, hydrogen sulphide and hydrogen, plus temperature, which tells a crew whether the air past the door is turning toxic or explosive. But none of that makes the machine autonomous, because the call on where to send it stays with the operator holding the controller.
The furnace run is the company's own set piece, so the 30 minute figure rests on Lesentech's account alone. Footage released with the demonstration shows the tracks and underside still glowing red after the machine left the heat, with the company lettering legible on the casing.
The same footage puts the robot through a live drill, spraying water into a burning oil trench while the crew stands well back. Lesentech's site carries the specification sheet beside the claim, listing the same cannon, the same remote link and the same endurance figure.
Beijing Lesentech says its RXR-M80D-AX2 kept working after 30 minutes at 1,000°C inside a furnace.
The 800 kg tracked machine carries an 80 litre per second water and foam cannon with an 85 m range.
It climbs 30 degree slopes, crosses 400 mm trenches, clears 170 mm obstacles and runs for four hours on a 1 km remote link.
Sensors watch carbon monoxide, methane, hydrogen sulphide and hydrogen, with thermal imaging aimed by the cannon.
The heat test is the company's own, and no independent measurement of the rating has been published.
Source: Interesting Engineering, Beijing Lesentech


